Bandwidth refers to the rate at which data is transferred over the communication link. You setup the bandwidth on a given interface (interface serial 0/0) to a specified value (64 kbps). You also set the clock rate to 64000. Note that bandwidth is represented in kbps whereas clock rate is entered in bps. The following command sets bandwidth on a interface serial 0/0 to a value 64 kbps and clockrate to 64000. Note that bandwidth is represented in kbps whereas clock rate is entered in bps.
R1> enable
R1#configure terminal
R1(config)#interface serial 0/0
R1(config-if)#bandwidth 64
R1(config-if)#clock rate 64000
R1(config-if)#exit
R1(config)#exit
The simulations are useful for assessing one's readiness for the actual exam, but they shouldn't serve as the only source of learning (Its highly recommended to have hands-on experience on a router.).
Please check below link for few CCNA simulation exercises for practicing.
https://www.simulationexams.com/simulation-questions/cisco-ccna.htm
No comments:
Post a Comment