Friday, April 29, 2011

CCNA Network Simulator now supports VLAN, VTP, and STP

The network simulator product now supports VTP (VLAN Trunking Protocol), VLANs (Virtual Local Area Networks), and STP (Spanning Tree Protocol). Further, several new labs have been added as below:

12.0 IPv6 Routing Protocol labs
12.1 Enabling RIPng (IPv6 RIP Process) on a cisco router interface
12.2 Enabling RIPng on two routers and pinging between them
12.3 Entering RIPng router configuration mode and setting global parameters on a cisco router
12.4 Configuring EIGRPv6 on a router interface
12.5 Configuring EIGRPv6 on two routers and pinging between them
12.6 Enabling OSPF for IPv6 on a Cisco router interface
12.7 Configuring OSPF on two router interfaces
12.8 General IPv6 configuration on 2610 series router
13.0 DHCP labs
13.1 Configuring cisco router as a DHCP server
13.2 DHCP client configuration
13.3 Configuring two DHCP clients and DHCP verification commands
14.0 Exercises on Spanning Tree Protocol
14.1 Enabling STP
14.2 Configuring root switch
14.3 Configuring port-priority
14.4 Configuring switch priority of a VLAN
14.5 Configuring STP timers
14.6 Verifying STP
Please refer to the lab exercises page of CCNA for complete list of labs provided. Note that the demo version will have access to limited number of labs, whereas it is possible to run all the labs in the
full version of the simulator

The supported commands are given below:

Product page:

No comments: